DownloadBook a demo
    An embedded test bench with an oscilloscope, a multimeter and a board under test

    Automate on QNX

    Test QNX interfaces without touching the target.

    HDMI capture in, actions out. The QNX target stays untouched.

    Book a demoDownload

    How it works

    The agent does
    what a tester does.

    Companion Mode · HDMI capture · Target untouched.

    Step 1

    Capture the screen externally.

    Companion Mode runs on separate hardware (a Raspberry Pi is enough) with HDMI capture. No software on the QNX target.

    Step 2

    The agent reasons about the HMI.

    It reads the rendered interface and interacts like an operator would.

    Step 3

    Verify beyond the screen.

    Combine UI checks with API and bus-level verification (CANoe, dSPACE, CanTools integrations).

    What do you get on QNX?

    What you get

    Built for QNX.

    • No instrumentation of the embedded target
    • Companion Mode through a Raspberry Pi
    • Automotive tool integrations: CANoe, dSPACE, CanTools
    • Same plain-English workflow as every other surface

    QNX specs

    At a glance
    Companion Mode · HDMI capture · Target untouched

    Run it on your QNX target.
    Send us ten test cases.

    Or download AskUI Desktop. No sign-up.